1 – Use:
The AVM-E2 harmonizer is to be placed on a large diameter water inlet pipe, when the AVM-E1 is insufficient.
This may be the case in particular in apartment buildings, on an industrial site or in breeding. This harmonizer is used in addition to the AVM-T (treatment of the earth connection) and the AVM-L (treatment of the arrival of electricity).
Note: This equipment is to be installed by an authorized person who can detect the overall action of the correction on the dwelling (house – apartment or any other building).
2 – Presentation:
This device is in the form of two half-shells.
The AVM-E2 is generally supplied as part of an in-house Kit, but can exceptionally be delivered individually, to correct an additional pipe (second well water circuit, etc.).
Contents: 1 x AVM-E2
3 – Technical characteristics:
Total dimensions: H 70 mm, Ø 32 / 48 mm
4 – Context of use:
Our places of life, work, or even leisure, are today more and more disturbed by new technologies.
These can be found at the level of transmitting structures in the environment of buildings (relay antennas, etc.), or equipment specific to the dwelling (boilers – water heaters – solar panels, etc.).
The use of lighter devices (WiFi – mobile phones – computers…) can also have an impact on the serenity, attention and vitality of the inhabitants.
The effects are aggravated by the multiplicity of frequencies received, as well as an unfavorable configuration of the geological basement (discontinuities).
It is necessary to improve the compatibility of places, and of this equipment, with the living.
5 – Operating principle:
Man-made electromagnetic waves, whatever their origin, can carry a signal that disturbs people, animals and plants.
It is a question of transforming the artificial wave information of our environment, often deleterious, into favorable signals for the living.
It is the informational imprints of plants and natural minerals embedded in the resin of the devices that allow this reversal of the effect.
They provide a repository close to nature, very useful to organisms for their functioning.
These devices make it possible to deal with nuisances originating from outside the domain or generated by equipment installed inside the buildings themselves.
They attenuate the effects of disturbances induced or potentiated by the geological nature of the subsoil (faults, cavities, embankments, telluric networks, presence of water, etc.).
6 – Expected effects:
Less fatigue, more comfort and well-being for most of the inhabitants of these previously disturbed places.
Sensitive people may experience immediate relief.
Most people will usually need a few extra days to weeks to experience effectiveness.
Other improvements in the situation, at the level of the walls (in the case of humidity by capillarity), or in the operation of electronic devices (during intermittent breakdowns) could also be observed in a few rare specific cases.
7 – Recommended location and instructions for installation:
This device is to be placed on the water inlet pipe in the house.
close to the circuit shut-off valve for example (in the garage – near the hot water cumulus…).
It should preferably be placed on a vertical segment where the water flows from bottom to top (maximum effect).
However, the other configurations also work.
In the case of an apartment, the shut-off valve is sometimes found in the toilets and the meter in a box on the landing.
If the pipe is not visible anywhere else, it sometimes happens to place the device around the arrival of cold water under the sink.
Check then that the harmonization has actually taken place on the other water points (bathroom sink, etc.) even if this water does not pass at the level of the kitchen sink.
The two half-shells must be placed around the pipe.
The two arrows are to be oriented in the direction in which the water is flowing.
The two collars (provided – type electrician’s collar) hold the harmonizer in place.
The two half-shells do not need to be contiguous to act, just parallel.
Note: this material can be used in the same way to correct, if necessary:
– a second water circuit equipping the house (rainwater – well …).
Use a second AVM-E1 or AVM-E2 corrector if the diameter of the pipe is large (drilling, etc.).
– the water circuit inlets of a heating system at the level of the nurse (on the return).
– a gas inlet pipe.
This pipe often acts as the effective “grounding” of the house.
However, all these secondary pipes, even when tested negative at the time of the diagnosis, will not systematically need to be corrected.
Test them again after installing the Home Kit (Wi-Fi included) to determine the real needs.
8 – Maintenance advice:
The devices can be cleaned with a slightly damp microfiber cloth in case of accumulated dust or stains.
Do not use solvents or other chemicals in contact with them.
Do not expose to temperatures above 60°C.
The devices are to be placed sheltered from bad weather.
9 – Warranty:
AVENI devices are guaranteed for 2 years (excluding adhesive) for any manufacturing-related problems.
10 – Other devices available:
Exceptionally, it could happen that the installation of the AVM-E2 alone, leads to an improvement of the situation, however, it is very strongly advised to use it in addition to the
AVM-T (on the ground), AVM-L (on the electricity meter) and AVL-85 (on the main electrical panel).
The synergy between these different devices allows better results. Other additional devices may prove necessary (see KIT-M or KIT-ME sheet).
The installation of additional devices such as AVB-M (in the house), AVB-A (in agriculture) or AVB-S (on an industrial site) may prove necessary in the most difficult cases.
Devices for vehicles (AV-CAR – AV-CARE and AV-CAM) can achieve a similar effect and are intended to remain in the vehicle.
The effect obtained will be better when commonly used electronic devices (mobile phones – tablets – computers…) are harmonized with AVENI devices.